Pump/Filter/Gunge trap assembly sequence 1.Prior to assembling the filter, remove the proprietary filter from the filter inlet bore.
	2. Check pump discharge diameter. Press the Adaption Tee (6) over the pump discharge pipe. If diameter is too small, use Rubber Tee Adaptor (*see list above). Position flow adjuster on Adaption Tee (6). If operating a fountain only set F under arrow, if operating waterfall only, or waterfall and fountain, set to W. See fine tuning flow adjustment in box overleaf, if you are unsure how to adjust. 3. Check pump inlet diameter, if necessary select an appropriate adaptor to enable the filter to be fitted to the pump. (Many of the larger pumps, no adaptor is required the filter will push straight over the pump inlet). 4. Press the filter outlet over bore of the pump inlet, on insert into adaptor, where used. 5. Fit the long end of connecting tube RF-7 on to the nipple of the filter before inserting the other end into the flow adjuster on the Adaptor Tee. Twist the filter and Adaptor Tee so that the connecting tube is not kinked. 6. If using the filter with the gunge trap ñ screw the Adaptor Tube Suction and Adaptor Elbow suction to the ends of the Suction tube. Check pump inlet diameters, if necessary select an appropriate adaptor. RF-4 or RF-5 (larger pumps often do not require adaptor.), to enable the straight adaptor on the suction tube to be fitted to the pump inlet. Fit the elbow to the filter (in the vertical position). 7. Fit the connecting tube (long) to the nipple of the filter and then insert the other end into the flow adjuster on the Adaptor Tee. Twist the filter and Adaptor Tee so that the connecting tube is not kinked. Insert the filter into the retaining spider of the gunge trap. 8. Fit fountain head as supplied with your pump, to the top of the Adaption Tee. A 1in. (25mm) pipe can be fitted directly to top of the Adaption Tee if the fountain head is not required. You are now ready to install the pump in the pond.